Skip to main content
Skip table of contents

Easykon for MyHome | Installation

Follow the steps outlined in this short article to perform the installation of Easykon for MyHome in just a few moments. At the end of this guide you will finally be able to make a BTicino MyHome home automation system smart.

How to install Easykon for MyHome and make BTicino MyHome home automation smart

For your safety and that of the components, turn off the power to the electrical system using the circuit breaker before proceeding with the installation of Easykon for MyHome.


Installing Easykon for MyHome is very simple, you just need to follow the steps below:

  1. Hook Easykon for MyHome to the DIN bar of the electrical panel

  2. Connect the 12/24 V 0.1 A power cable to the upper left connector

  3. Connect the Ethernet cable to the upper right connector

  4. Check the correctness of the cabling and reconnect the power supply

After about 30 seconds, the Easykon for MyHome status light will turn fixed magenta.

Now you can Map the accessories inside your Easykon. Place accessories within Easykon

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.