Skip to main content
Skip table of contents

Easykon for KNX | Installation

Follow the steps outlined in this short article to perform the installation of Easykon for KNX in just a few moments. At the end of this guide you will finally be able to make a KNX home automation system smart.

How to install Easykon for KNX and make KNX home automation smart

For your safety and that of the components, turn off the power to the electrical system using the circuit breaker before proceeding with the installation of Easykon for KNX.


  • 12/24 V AC/DC 0.1 A power supply (e.g. Power supply 12 V) 

  • KNX bus cable

  • Ethernet cable with RJ-45 connector for connection to the local network (LAN)

  • List of group addresses or ETS project files (.xml or .knxproj) of compatible accessories

Installing Easykon for KNX is very simple, you just need to follow the steps below:

  1. Hook Easykon for KNX to the DIN bar of the electrical panel

  2. Connect the 12/24 V 0.1 A power cable to the upper left connector

  3. Connect the Ethernet cable to the upper right connector

  4. Connect the KNX bus cables following the colour of the connector on the lower side

  5. Check the correctness of the cabling and reconnect the power supply

After about 30 seconds, the Easykon for KNX status light will turn fixed blue.

Now you can Map accessories within Easykon fo KNX. Enter accessories within Easykon

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.